These parameters should match on the remote firewall for the IKE Phase-2 negotiation to be successful. Under Network > Network Profiles > IPSec Crypto , click Add to create a new Profile, define the IPSec Crypto profile to specify protocols and algorithms for identification, authentication, and encryption in VPN tunnels based on IPSec SA negotiation (IKEv1 Phase-2). The firewall will only respond to IKE connections and never initiate them.Įxchange Mode - The device can accept both main mode and aggressive mode negotiation requests however, whenever possible, it initiates negotiation and allows exchanges in main mode If you don’t specify a value, the gateway will use the local/peer IP address as the Local/Peer Identification value.Įnable Passive Mode - The firewall to be in responder only mode. Local and Peer Identification: Defines the format and identification of the local/peer gateway, which are used with the pre-shared key for both IKEv1 phase 1 SA and IKEv2 SA establishment.Ĭhoose one of the following types and enter the value: FQDN (hostname), IP address, KEYID (binary format ID string in HEX), or User FQDN (email address). Interface: The external interface connected to the internet. Otherwise, the gateway falls back to IKEv1. Select the IKE version that the gateway supports and must agree to use with the peer gateway. IKEv2 preferred mode causes the gateway to negotiate for IKEv2, and if the peer also supports IKEv2, that is what they will use. Version: There are options for the Version where you can select IKEv1 only mode, IKEv2 only mode or IKEv2 preferred mode. Go to Network > Network Profiles > IKE Gateway to configure the IKE Phase-1 Gateway. These parameters should match on the remote firewall for the IKE Phase-1 negotiation to be successful. Name does not matter, can be whatever you like. Go to Network > Network Profiles > IKE Crypto, click Add and define the IKE Crypto profile (IKEv1 Phase-1) parameters. You would need ip-address if you intend to run dynamic routing protocols over the tunnel interface. NOTE: If the tunnel interface is in a zone different from the zone where the traffic will originate or depart, then a policy is required to allow the traffic to flow from the source zone to the zone containing the tunnel interface.Ĭonfiguring ip-address on the tunnel interface is optional.
– Security Zone:(configure a new zone for the tunnel interface for more granular control of traffic ingress/egressing the tunnel)
– Virtual router: (select the virtual router you would like your tunnel interface to reside) Go to Network >Interface > Tunnel tab, click Add to create a new tunnel interface and assign the following parameters: The transport mode is not supported for IPSec VPN. NOTE: The Palo Alto Networks supports only tunnel mode for IPSec VPN.
0 kommentar(er)
